themes/bobi2016

Installation on BOBI ROUND stand

tools 120

BOBI ROUND stand is installed over the letterbox. It fits all "roundtop" BOBI letterbox modells (not BOBI BELLA and BOBI XPRESS). All fittings and fixing instructions are included in the stand package.

You need: A drill, 6-7 mm drillbit for steel, a vacuum cleaner, a screwdriver, a tape measure and a spade to dig the hole.
We recommend using concrete for a secure and solid installation. If you are uncertain about the placement please contact your local postoffice prior to your installation.

More measurement information for installation here.

drill06There are preformed markings for fixing holes on the sides of the letterbox.

drill05Place the letterbox side down on a surface that will not scratch it.

Using a 6-7 mm drillbit for steel...

drill03Drill out the holes with low speed and clean the holes and remove all the metal remnants. Be careful not to scrach the surface. We recommend using a vacuum cleaner to ensure all the small metal parts are removed from the holes, seams and bottom of the letterbox. Otherwise, metal remnants can, over time, start to rust.

round01All the fittings are provided....

round02Fasten the parts together from inside the letterbox

dig01Dig ca. 40 cm deep mounting hole. 

round03Check the level.

measure01Check the correct height of the aperature.

round04Fill the mounting hole with gravel or concrete.

round05BOBI ROUND stand fits all "roundtop" BOBI letterbox models.

keys01Write down and save the key code.